2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
RECOMMENDED CUTTING CONDITIONS
Work Hardness Grade Cutting Speed (m/min) Feed per Tooth (mm/tooth)
Material 180 280HB VP15TF 250 (150 350) 0.1 (0.05 0.15)
P 280 380HB VP15TF 200 (100 300) 0.1 (0.05 0.15)
350 (200 500) 0.1 (0.05 0.15)
Carbon Steel 0.1 (0.05 0.15)
Alloy Steel 1500 (1000 2000)
K Tensile Strength AP10H
Cast Iron < 350MPa MB710
Ductile Tensile Strength AP10H 250 (150 350)
Cast Iron 360 500MPa MB710 1000 (800 1200)
AP10H
Tensile Strength MB710 200 (100 300)
500 800MPa 1000 (800 1200)
a Revolution (min-1)=(1000Cutting Speed)(3.14&D1)
a Table Feed (mm/min)=Feed per ToothNumber of TeethCutter Revolution
(Note 1) Recommended radial depth of cut is 0.1mm.
(Note 2) 2 directional vertical cutting is recommended for efficiency.
(Note 3) For crossfeed cutting, feed per tooth should be reduced to less than 0.05 (mm/tooth).
ROTATING TOOLS
SPARE PARTS M001
TECHNICAL DATA
N001 K113
info@mitsubishitools.ru www.mitsubishitools.ru
