2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                      для заказа - info@mitsubishitools.ru

y OPERATIONAL GUIDANCE                Drill Length                                        Drill Installation                                                           CARBIDE
          Drill Holding
                                                                                                                            Installation Tolerance

Adjusting Screw
                                                                                       A

Thrust bearing type collet                  D1                                           Do not clamp on the flutes.         Run-out < 0.03mm
chuck holds the drill securely.
                                          A > D1 x 1.5                                       Thin Workpiece                 Interrupted Cutting
     Coolant Method
                                      Drill Installation                                                        If Bending                One Process
                                                                                                                  Occurs
                                                                                                                                           zLower the feed
                                 1D1                                                                                                           when drillng
                                                                                                                                               the interrupted
                                 zWhen machining a prepared hole                             Support                                          part.
                                    with the stub type drill please set                   the Workpiece
                                    the depth to 1D (D=drill diameter).                                                                   Requires Prior
Two coolant positions, at the                                                                                                             Machining
end and at the center are        xUse the prepared hole as a
ideal.                              guide when using a drill with                                                                          zSpot face with an
                                    an oil hole. Depending on the                                                                              end mill prior to
      Stepped Holes                 cutting conditions, peck feed                                                                              drilling.
                                    is recommended.

                                 Burring and Workpiece Chipping

                                                                                                                                                                  DRILLING

zDivide the two processes.       zLower the feed rate by 50%
xDrill the larger hole first.
                                    at the end of through
*A tool for machining both
                                    cutting.
 chamfer and spot face can       xAdd a 45°chamfer.
                                 cChange the point angle.
 be produced to order.

                                      info@mitsubishitools.ru                             www.mitsubishitools.ru            L027TECHNICAL DATA N001