2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                  для заказа - info@mitsubishitools.ru

                                                                                                                                                       CBN & PCD TURNING INSERTS

                                                                          *Thickness is from the bottom of the insert
                                                                            to the top of the cutting edge.

                                                                             Symbol     Thickness (mm)

Diameter of                            Symbol                                S1 1.39

Inscribed Circle  R        W        V  D       C              S  T           01 1.59
    (mm)

3.97 02 04 03 03 06                                                          T0 1.79                                        Symbol Corner Radius (mm)

4.76 L3 08 05 04 04 08                                                       02 2.38                                          02 0.2
                                                                                                                              04 0.4
5.56 03 09 06 05 05 09                                                       T2 2.78                                          08 0.8
                                                                                                                              12 1.2
6.35 04 11 07 06 06 11                                                       03 3.18                                          16 1.6
                                                                                                                        , Insert Corner Configuration
7.94 05 13 09 08 07 13                                                       T3 3.97

9.525 09 06 16 11 09 09 16

12.70             12 08 22 15 12 12 22                                       04 4.76
                                                                             m Insert Thickness
                              n Insert Size

            nm,

15 04 04 GA W 2 J R
                                                                                       . / u11 u12 u13

. Application (Honing)                          / Wiper          u11 Number of Teeth   u12 Cutting Edge Angle           u13 Cutting Direction
                                          WS                                                                                Figure Hand Symbol
Symbol            Honing                  WC With Wiper          22                       F 91°                                           Right R
                                          W
GA                                     No mark Without Wiper     33                       J 93°                                            Left L

GS      Continuous Cutting                                      44                   No mark Non Restriction
        Medium Interrupted Cutting
                                                                                      Please pay special attention
GN                                                               66                   when using wiper inserts.
                                                                                      Please refer to page B014 for
FA                                                               No mark  1           further information.

FS Continuous Cutting

FN                                                                                                                      Neutral N

TA

TS Interrupted Cutting

TN

Please refer to page B011
for further information.

                                               info@mitsubishitools.ru    www.mitsubishitools.ru                                                       B003