2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
BORING BARS
FEATURES OF DIMPLE BAR
Highly rigid steel shank and a lightweight head configuration Chip disposal is improved by having
designed by computer simulation analysis reduces chatter two channels for chip evacuation.
and improves the vibration damping properties.
The lightweight head with its large
BORING dimple reduces chatter.
Available in sizes smaller than the ISO
standard. Therefore the boring of
small diameter holes is possible.
The boring bar has a laser printed
scale on the shank to facilitate easy
installation.
"F and FS" breakers improves the quality
of the surface finish, "MV" breaker offers
excellent chip disposal. High wear
resistant CBN inserts are also available
for the machining of hardened materials.
y DEFLECTION RESISTANCE y VIBRATION RESISTANCE
a DIMPLE BAR Weight of the Damping Time
Head 15.8ms
49.7g
Cutting Force Cutting Force
(Back Force) (Principal Force)
By reducing the weight of the head, the damping
properties are increased.
a Conventional Product Weight of the Damping Time
Head 20ms
70.1g
The unique cross sectional Boring Bar Deflection
shape engineered into the DIMPLE BAR 28.3!m
dimple effectively balances Conventional Bar 34!m
the cutting forces (principal
and back force), and reduces
deflection by up to 17%.
* The simulation data stated above was conducted with a FSCLP1816R-09A holder, under the following conditions;
l/d=5, depth of cut=0.5mm, and feed=0.05mm/rev.
y Notes for the use of CCG/MT • CPG/MT • CPMX • TPG/MX type inserts
By changing the clamp screw, it is possible to use the inserts listed on the table below.
Holder : FSCLC/P•FSCLC/P...E Holder : FSTUP•FSTUP...E
Insert Number Clamp Screw Insert Number Clamp Screw
CCG/MT0602oo (& 6.35) Can be used as it is. TPG/MX0802oo (& 4.76) Change to CS200T
CPG/MT0802oo (& 7.94) Change to TS3 TPG/MX0902oo (& 5.56) Change to CS250T
CPG/MT0903oo (& 9.525) Change to TS4 TPG/MX1103oo (& 9.525) Change to CS300890T
CPMX0802oo (& 7.94) Can be used as it is.
CPMX0903oo (& 9.525) Can be used as it is.
* If the screw is too long, please cut to length.
(Note) TPMT/W09, W11 types cannot be used due to a different clamp screw size.
E006 info@mitsubishitools.ru www.mitsubishitools.ru