2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                   для заказа - info@mitsubishitools.ru

 MACHINING RECOMMENDATIONS

a Notes on multi-functional machining (MF,MS,MM and BM breakers)

Machining narrow grooves                                                          Machining wide grooves

                        xcz

aIt is recommended to carry out plunging in several passes.            aIt is recommended that cross-feed machining is used.
  Following the steps above makes it difficult for chips to elongate.
  This also improves the accuracy of workpiece wall surface.

                                                   Machining wide grooves                                                                        GROOVING

                        ROUGHING                                                               FINISHING

x                                       c             n                                        m,
   z                               v                     b

zCarry out grooving.    c Carry out cross feed        b Carry out grooving.              m Carry out grooving    , Machining of the wall
xRetract the tool          machining.                 n Retract the tool approx             to the end point of     surface, corner radius and
                                                                                            the corner radius.      bottom face should be
   approx 0.1mm.        v Retract the tool approx        0.1mm.                                                     carried out in one process.
                           0.1mm.                     * Repeat the steps z – n .

                        FINISHING                                                        Precautions when finishing walls

      .
                                /

.Stop at the bottom of  / Machine the counter         Finish machining.
   the corner radius.      wall to the corner radius
                           in one process.                                               aTo produce high accuracy walls using MS or MM
                                                                                           breaker insert, do not carry out back turning.
                        Wall machining                                                     Plunging is recommended.

                                                                                         Machining of a ring section

aWhen machining a wall, chip jamming can occur. In this case, stop       aWhen a ring remains in a cross feed end process,
  cross feed machining just before the wall (at a point less than the      finish cross feed machining 1 – 1.5mm short of the
  insert width) then remove the remaining material by plunging.            end point, then remove the ring by plunging.

                                   info@mitsubishitools.ru             www.mitsubishitools.ru                                                    F043