2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                для заказа - info@mitsubishitools.ru

a Notes when setting the tool                                          When intertering the wall of groove and the Modular blade

        Setting the cutting edge height

                             +                                                                          +                                    GROOVING

                             –                                                                –

aSet the cutting edge height to ±0.1mm parallel to the central axis.  aIf interference occurs even when the correct blade is used,
aCutting edge centre height check should be done by traverse            the cutting edge height could be incorrect.
                                                                            When interference occurs on the inner side of the blade, the
  machining towards the centre with a very small depth of cut               cutting edge height is set too high.
  and ensure that an even surface and no material remains at                When interference occurs on the outer side of the blade, the
  the centre point afterwards.                                              cutting edge height is set too low.

Setting the tool                                                                      Tool overhang

Parallel                                        Parallel

aSet the insert parallel to the central axis.                         aWhen setting the tool, ensure that the overhang is as short as
                                                                         possible and avoid the step difference part as above figure shows.

  MACHINING RECOMMENDATIONS

a Notes when face grooving (1)

aAlways machine from the outer diameter towards the centre.

Machining narrow grooves                                               Machining wide grooves

                                             z                                                                cxz
                                            x                          aC ross feed machining is recommended.
                                          c

aPlunging in several passes is recommended.

          info@mitsubishitools.ru                                      www.mitsubishitools.ru                                                F107