2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
CARBIDE
RECOMMENDED CUTTING CONDITIONS
y Slotting
Work Carbon steel, Cast iron, Alloy steel, Tool steel,
material Alloy steel ( 30HRC) Pre-hardened steel
Cf53, GG25 X40CrMoV51
Dia. Revolution Feed rate Depth of cut Revolution Feed rate Depth of cut SOLID END MILLS
(mm) (min-1) (mm/min) (mm) (min-1) (mm/min) (mm)
0.2 40000 400 0.001 30000 250 0.001
0.3 40000 600 0.005 35000 420 0.005
0.4 40000 700 0.007 30000 420 0.007
0.5 40000 800 0.01 24000 380 0.01
0.6 33000 800 0.015 21000 480 0.01
0.7 28000 800 0.015 18000 480 0.015
0.8 25000 800 0.02 16000 480 0.02
0.9 22000 800 0.03 15000 500 0.03
1 20000 800 0.04 13000 500 0.04
1.5 13000 800 0.10 500 0.10
2 10000 800 0.15 9000 500 0.15
2.5 800 0.20 6700 500 0.20
3 9000 800 0.20 6000 460 0.20
4 8000 600 0.20 5200 340 0.20
5 6000 480 0.30 4000 280 0.20
6 4800 400 0.30 3200 210 0.20
8 4000 300 0.30 2600 170 0.30
10 3000 240 0.30 2000 140 0.30
12 2400 200 0.30 1600 110 0.30
2000 1300
D D:Dia.
Depth of < Please refer to the list above Depth of cut
cut for depth of cut. (mm)
y Shoulder milling 0.03
0.03
Work Carbon steel, Cast iron, Alloy steel, Tool steel, 0.03
material Alloy steel ( 30HRC) Pre-hardened steel 0.03
0.04
Cf53, GG25 X40CrMoV51 0.05
0.06
Dia. Revolution Feed rate Depth of cut Revolution Feed rate
(mm) (min-1) (mm/min) (mm) (min-1) (mm/min) D:Dia.
3 3500 370 0.05 2600 250
4 2800
5 2200 370 0.06 2100 200
6 1800
8 1600 330 0.06 1700 160
10 1400
12 1200 300 0.06 1500 140
270 0.08 1100 140
240 0.10 900 140
200 0.10 750 120
< Please refer to the list above for depth of cut.
Depth of < 3D
cut
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) When drilling, please set the feed rate at 1/3 or below the values above.
3) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and
feed rate proportionately.
info@mitsubishitools.ru www.mitsubishitools.ru I043