2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
MS4SC MS4MC CARBIDE
End mill, Short cut length, 4 flute End mill, Medium cut length, 4 flute
RECOMMENDED CUTTING CONDITIONS
Carbon steel, Cast iron, Alloy steel, Hardened steel (45 55HRC)
Work Pre-hardened steel X40CrMoV51
material Cf53, GG25
Dia. Revolution Feed rate Depth of cut Revolution Feed rate Depth of cut
(mm) (min-1) (mm/min) (mm) (min-1) (mm/min) (mm)
1 40000 3000 0.06 32000 2400 0.06
1.5 40000 4500 0.12 32000 3600 0.08
2 30000 4500 0.18 24000 3600 0.10
2.5 24000 3900 0.25 19000 3000 0.13
3 20000 3500 0.30 16000 2700 0.15
4 15000 3000 0.40 12000 2400 0.20
5 12000 2400 0.50 1800 0.25
6 10000 9000 1500 0.30
8 2100 0.60 7000 1100 0.40
10 8000 5600 0.50
12 6400 1500 0.80 4500 950 0.50
16 5400 3800 860 0.80
20 2400 1400 1.00 1200 120 1.00
1900 1000 100
1200 1.00
D
550 3.00
480 4.00
< Please refer to the list above
for depth of cut.
Depth of < 1D < Please refer to the list above
cut for depth of cut.
D:Dia. SOLID END MILLS
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) When slotting with end mills with & 3 or larger, reduce the revolution to 50 70% and the feed rate to 40 60%.
3) When drilling, please set the feed rate at 1/3 or below the values above.
4) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and
feed rate proportionately.
info@mitsubishitools.ru www.mitsubishitools.ru I061