2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
CARBIDE
RECOMMENDED CUTTING CONDITIONS
Work material Carbon steel, Cast iron, Alloy steel, Work material Carbon steel, Cast iron, Alloy steel,
Pre-hardened steel Pre-hardened steel
Cf53, GG25 Cf53, GG25
Dia. Neck length Revolution Feed rate Depth of cut Dia. Neck length Revolution Feed rate Depth of cut
(mm) (mm) (min-1) (mm/min) ap (mm) (mm) (mm) (min-1) (mm/min) ap (mm)
4 40000 3000 0.04 15 20000 3000 0.6
36000 2400 0.03 25 11000 1600 0.15
1 8 20000 1000 0.02 3.5 35 0.06
12 10000 0.005 4 12 5500 800 1
40000 500 0.05 20 18000 3000 0.5
16 36000 3000 0.04 5 30 12000 2000 0.2
20000 2400 0.03 6 40 1300 0.08
6 12000 1200 0.01 8 50 8000 0.03
40000 0.06 10 16 4200 700 1
1.2 10 32000 600 0.05 25 2400 400 0.5
12 16000 3200 0.03 35 14000 2700 0.2
10000 2400 0.01 50 9500 1800 0.05
16 40000 1100 0.08 20 6400 1200 1.2
32000 0.06 30 3200 600 0.6
6 12000 600 0.02 40 11000 2200 0.25
3600 0.01 50 8000 1600 0.15
1.5 12 7000 2800 0.1 30 5400 1100 1.6
16 40000 1000 0.07 50 3200 640 0.5
32000 0.05 70 8000 1600 0.2
20 24000 600 0.03 40 4000 800 2
12000 4000 0.01 60 2000 400 0.6
6 3200 0.2 80 6400 1300 0.3
5000 2400 0.04 3200 640
1.8 12 32000 1200 0.005 1600 320
20 0.4
9000 500 0.2
25 2500 4000 0.1
25000 1100 0.05
6 18000
12000 300
12 7000 3600
2500
2 16 1700 SOLID END MILLS
20 800
30
8
2.5 25
50
8
3 16
25
30
ap:Depth of Cut in the Axial Direction
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) Cutting conditions may be considerably different due to the overhang (milling depth), depth of cut, and machine tool. Please see the above
table as a standard.
info@mitsubishitools.ru www.mitsubishitools.ru I067