2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
CARBIDE для заказа - info@mitsubishitools.ru
MSTAR END MILLS
MS4MRBaaaE
End mill, Medium cut length, 4 flute, Corner radius
RECOMMENDED CUTTING CONDITIONS
Carbon steel, Alloy steel Alloy steel, Tool steel, Stainless steel Hardened steel
( 30HRC) (45 55HRC)
Work Pre-hardened steel
material Cast iron (30 45HRC)
Dia. Revolution Feed rate Revolution Feed rate Revolution Feed rate Revolution Feed rate
(mm) (min-1) (mm/min) (min-1) (mm/min) (min-1) (mm/min) (min-1) (mm/min)
1 40000 1200 32000 960 27000 675 24000 270
1.5 30000 1350 21000 900 18000 675 15000 270
2 22500 1350 15000 900 13650 675 12000 270
3 15000 1350 10500 900 675 270
4 11250 1350 900 9000 675 7500 270
5 1350 7800 900 6750 675 6000 270
6 9000 1350 6300 900 5400 675 4800 270
8 7500 1170 5250 780 4500 585 4050 240
10 6000 1020 4200 675 3600 510 3000 210
12 4800 1020 3300 615 2850 465 2400 180
16 4050 2850 480 2400 345 1950 150
3000 870 2400 1950 1650
Depth of
cut < 0.1D (D > & 3) < 0.05D
< 0.2D (D > & 3)
< 1.5D < 1D
D D
< 0.05D (D < & 2)
SOLID END MILLS < 0.1D (D < & 2)
< 0.01D (D > & 2)
< 0.2D (D > & 2)
D:Dia.
Titanium High Nickel
Inconel
Work
material
Dia. Revolution Feed rate Revolution Feed rate
(mm) (min-1) (mm/min) (min-1) (mm/min)
1 20000 500 10000 110
1.5 12800 400 6400 110
2 400 4800 110
3 9500 400 3100 110
4 6400 480 2400 110
5 4800 400 1900 110
6 4000 400 1600 110
8 3100 300 1200 100
10 2400 300 900
12 1900 250 800 80
16 1600 180 600 80
1200 60
Depth of
cut < 0.1D (D < & 3)
< 0.2D (D > & 3)
< 1.5D
D
< 0.1D (D < & 2)
< 0.2D (D > & 2)
D:Dia.
1) When using high efficiency conditions, the surface speeds/feeds can be increased by 2-3 times the above values.
D < 0.05D
< 0.05D < 1.5D
I130 info@mitsubishitools.ru www.mitsubishitools.ru