2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                                                                                      для заказа - info@mitsubishitools.ru

                 MSTAR END MILLS

CARBIDE          MSSHV                                                                                                                                 UWC MS                                  43°
                                                                                                                                                                                               45°
                 Variable helix end mill, Short cut length, 4 flute,                                                                                                                    Copper Alloy
                 Reduced neck, Cylindrical shank

                 Carbon Steel, Alloy Steel, Cast Iron Tool Steel, Pre-Hardened Steel, Hardened Steel  Hardened Steel  Hardened Steel     Austenitic       Titanium Alloy,                             Aluminium Alloy
                 (<30HRC)  ( < 45HRC)                                                                    ( < 55HRC)                   Stainless Steel  Heat Resistant Alloy
                                                                                                                        (>55HRC)
                 ee                                                                                          u                              e                   u

SQUARE                                                                                                                                D1                                                                                          Type1
                                                                                                                                                                  D5
                                                                                                                                                                                                                                 Unit : mm
                                                                                                                                                                                                                        D4(h6)

                                                                                                                                                            ap
                                                                                                                                                                 L3

                                                                                                                                                                             L1

BALL             D1 <12    D1>12

                 	0        	0
                 -	0.020   -	0.030

                 D4=6 8 55HRC)
                 ee                                                                                          u                              e                   u

                                                                                                                                      D1                                                             D4(h6)                    Type1

                                                                                                                                                            ap
                                                                                                                                                                                    L1

                 D1 <12    D1>12

                 	0        	0
                 -	0.020   -	0.030

                 D4=6 8