2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
VC2PSB VC2PSBP CARBIDE
Ball nose, Short cut length, 2 flute, Ultra high precision Ball nose end mill, Short cut length, 2 flute, Ultra high precision
RECOMMENDED CUTTING CONDITIONS
Alloy steel, Tool steel, Hardened steel (45 55HRC)
Work Pre-hardened steel X40CrMoV51
material X40CrMoV51
R % < 15° %>15° % < 15° %>15°
(mm)
Revolution Feed rate Revolution Feed rate Revolution Feed rate Revolution Feed rate
R0.05 (min-1) (mm/min) (min-1) (mm/min) (min-1) (mm/min) (min-1) (mm/min)
R0.1
R0.15 40000 200 40000 170
R0.2 40000 600 40000 400 40000 600 40000 400
R0.25 40000 900
R0.3 40000 1000 40000 600 40000 900 40000 600
R0.35 40000 1500 40000 700 40000 1000 40000 700
R0.4 40000 2000 40000 1000 40000 1500 40000 1000
R0.45 40000 2800
R0.5 40000 2800 40000 1500 40000 2000 40000 1500
R0.75 40000 3200
R1 40000 3200 40000 2100 40000 2800 37000 1800
R1.5 40000 3600 40000 2100 40000 2800 35000 1800
R2 35000 3500 38000 2200 38000 3000 32000 1800
R2.5 30000 3400
R3 25000 3400 35000 2200 35000 3000 30000 1800
R4 23000 3400
R5 20000 3400 30000 2300 32000 3000 25000 1800
R6 15000 3000 25000 2200 28000 2800 20000 1700
12000 3000 23000 2200 24000 2600 16000 1500
10000 2600
20000 2200 20000 2600 14000 1500
17000 2200 18000 2600 12000 1500 End mill ap
15000 2200 16000 2600 10000 1400 SOLID END MILLS
12500 2000 10000 2000 1200 R
7500 %
10000 2000 8000 2000 6000 1200 pf
8300 1800 6600 1700 5000 1100
< 0.1R
Depth of < 0.06R
cut
R:Radius
1) % is the inclination angle of the machined surface.
2) If the depth of cut is shallow, the revolution and feed rate can be increased.
3) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and
feed rate proportionately.
info@mitsubishitools.ru www.mitsubishitools.ru I243