2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                             для заказа - info@mitsubishitools.ru

                                                                                                                                                     CARBIDE

RECOMMENDED CUTTING CONDITIONS

 Work                 Copper, Copper alloys
material

  Dia.    Revolution         Feed rate           Depth of cut
 (mm)       (min-1)          (mm/min)                (mm)

  0.2     40000               600                  0.01                                                                                              SOLID END MILLS
  0.3     40000               600                  0.01
  0.4     40000               800                  0.01
  0.5     40000               960                  0.015
  0.6     40000              1200                  0.02
  0.7     40000              1400                  0.02
  0.8     40000              1600                  0.03
  0.9     40000              1800                  0.04
  1       40000              2000                  0.06
  1.5     40000              3000                  0.12
  2       30000              3000                  0.18
  2.5     24000              2600                  0.25
  3       20000              2300                  0.30
  4       15000              2000                  0.40
  5       12000              1600                  0.50
  6       10000              1400                  0.60
  8                          1000                  0.80
10         8000               900                  1.00
12         6400               820                  1.00
           5400
Depth of                                     < Please refer to
   cut    < Please refer to the list above    the list above
                                               for depth of cut.
          for depth of cut.  D
                                                                D:Dia.
          < 1D

1)	If the depth of cut is shallow, the revolution and feed rate can be increased.
2)	Water-soluble cutting fluid is recommended.
3)	When drilling, please set the feed rate at 1/3 or below of the table value.
4)	If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and

   feed rate proportionately.

                                             info@mitsubishitools.ru    www.mitsubishitools.ru                                                       I253