2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                     для заказа - info@mitsubishitools.ru

                                                                                                                                                     CARBIDE

RECOMMENDED CUTTING CONDITIONS

 Work                         Copper, Copper alloys
material

    R            % < 15°                %>15°              Depth of cut
  (mm)                                                         (mm)
          Revolution  Feed rate  Revolution  Feed rate
R0.2        (min-1)   (mm/min)     (min-1)   (mm/min)         0.02
R0.3                                                          0.03
R0.4      40000        1600      40000               1200     0.05
R0.5      40000        3200      40000               1600     0.06
R0.75     40000        6400                                   0.09
R1        40000        8000      40000               2400     0.11
R1.25     40000        9600                                   0.12
R1.5      40000        9600      40000               3200     0.13
R2        40000       12000      40000               4000     0.15
R2.5      40000       12000      39000               4700     0.20
R3        32000       11000                                   0.25
R4        25000        9000      30000               4500     0.30
R5        21000        8400                                   0.50
R6        16000        6400      27000               4300     0.50
          13000        5200      20000               3600
                       3600      16000               2900
           9000
                                 13000               2600                End mill

                                 10000               2000                           R
                                  8000               1700                                   %
                                  6000               1300
                                                                         pf
Depth of              < 0.2R                                                                     ap
   cut                                                                                                                                                                SOLID END MILLS
                                 < Please refer to the list above

                                 for depth of cut.         R:Radius

1)	% is the inclination angle of the machined surface.
2)	If the depth of cut is shallow, the revolution and feed rate can be increased.
3)	Water-soluble cutting fluid is recommended.
4)	If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and

   feed rate proportionately.

                                        info@mitsubishitools.ru          www.mitsubishitools.ru                                                      I259