2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
CARBIDE
RECOMMENDED CUTTING CONDITIONS
Work material Copper, Copper alloys Work material Copper, Copper alloys
R Neck length Revolution Feed rate Depth of cut R Neck length Revolution Feed rate Depth of cut
(min-1) (mm/min) (mm) (min-1) (mm/min) (mm)
(mm) (mm) (mm) (mm)
40000 800 0.003 40000 8000 0.07
0.5 40000 600 0.002 8 35000 4500 0.04
40000 400 0.001 20000 2000 0.03
R0.1 1.0 40000 1200 0.007 R0.75 12 12000 0.02
40000 800 0.003 16 40000 900 0.10
1.5 40000 2000 0.015 40000 9600 0.08
40000 1300 0.01 40000 6400 0.08
R0.15 1 40000 800 0.005 20 30000 6000 0.05
2 40000 2000 0.02 20000 3000 0.04
40000 1200 0.01 8 10000 2000 0.02
36000 600 0.006 40000 0.10
1 26000 200 0.002 10 25000 800 0.08
40000 3200 0.03 12000 0.06
R0.2 2 40000 1200 0.008 R1 12 6000 0.15
3 30000 500 0.003 16 32000 6000 0.15
40000 4000 0.02 32000 700 0.10
2 40000 2500 0.02 20 20000 0.08
4 30000 700 0.008 15000 11000 0.05
R0.25 6 40000 6400 0.05 30 9000 0.20
40000 4800 0.03 8000 4500 0.15
40000 3000 0.02 16 25000 3000 0.20
33000 2000 0.01 20000 1000 0.15
10 18000 500 0.008 R1.5 25 21000 9500
13000 250 0.005 35 20000 3300 R:Radius
2 8400
3000
R0.3 6 16
20
10
4 R2 30
R0.4 6 40 SOLID END MILLS
10 50
4 R2.5 20
30
6
R0.5 8 R3 30
10 50
16
20
< 0.2R
Depth of cut < Please refer to the list above
for depth of cut.
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) Water-soluble cutting fluid is recommended.
3) Cutting conditions may be considerably different due to the overhang (milling depth), depth of cut, and machine tool. Please see the above
table as a standard.
info@mitsubishitools.ru www.mitsubishitools.ru I263