2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                  для заказа - info@mitsubishitools.ru

                                                                                                                                                     CARBIDE

RECOMMENDED CUTTING CONDITIONS

      Work material                 Copper, Copper alloys

Dia.  Corner radius     Revolution  Feed rate           Depth of cut
(mm)       (mm)           (min-1)   (mm/min)
                                                   ap         ae
                                      1400        (mm)       (mm)
                                      1700
6     R0.2, R0.3, R0.5  10000         1000              6 0.6
      R1                10000         1200              6 0.6

8     R0.3, R0.5         8000          900              8 0.8
      R1                 8000         1100              8 0.8
                         6400
10    R0.3, R0.5         6400          800        10 1.0
      R1                 5400         1000        10 1.0
                         5400
12    R0.3, R0.5                            < ae  12 1.0
      R1                                          12 1.0

                                                  < ap

      Depth of cut

1)	If the depth of cut is shallow, the revolution and feed rate can be increased.                                                                    SOLID END MILLS
2)	Water-soluble cutting fluid is recommended.
3)	If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and

   feed rate proportionately.

                                    info@mitsubishitools.ru           www.mitsubishitools.ru                                                         I265