2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                            для заказа - info@mitsubishitools.ru

                                                                                                                                                   CARBIDE

RECOMMENDED CUTTING CONDITIONS

 Work                      Aluminium alloy
material

   Dia.   Revolution                          Feed rate  Slotting
  (mm)      (min-1)                           (mm/min)
                                                          1600
    3          40000       Side milling                   2100
    4          36000                                      2700
    5          30000          1800                        2800
    6          27000          2400                        3000
    8          20000          3000                        3200
  10           16000          3200                        3200
  12           13000          3400                        3200
  16           10000          3600                        3000
  20                          3600
                 8000         3600
Depth of                      3300
   cut    < 0.5D
                             D

                       1D                   < 1D

                                                                   D:Dia.

1)	This table shows the cutting condition with less than 4D overhang length. If more than 4D, spindle speed, feed rate and depth of cut should    SOLID END MILLS

   be reduced.
2)	If the rigidity of the machine or the workpiece installation is very low, or chattering and noise are generated, please reduce the revolution

   and the feed rate proportionately.
3)	Water-soluble cutting fluid is recommended.
4)	Climb cutting is recommended for side milling.

                           info@mitsubishitools.ru                 www.mitsubishitools.ru                                                          I297