2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
TURNING INSERTS
TURNING INSERTS CLASSIFICATION
Rough Cutting Application
NEGATIVE INSERTS WITHOUT HOLE
Tolerance
Breaker Name Features Cross Section
and Geometry
Picture
R/L-M1/2 Rough cutting of carbon steel and alloy steel Carbon Steel • Alloy Steelap (mm) Flank
0.2
Single sided chipbreaker. 7
M Can be used for copying. 5
An angled chipbreaker for controlling chip flow. 3 12°
1
0 0.1 0.3 0.5 0.7
f (mm/rev)
Flat Top Heavy cutting of cast iron Cast Ironap (mm) 0°
For Cast Iron Double sided flat insert. 7
M Most effective for unstable machining due to high edge 5
strength and stable insert clamping. 3
1
0 0.1 0.3 0.5 0.7
f (mm/rev)
Flat Top For cast iron Cast Iron
7
Double sided flat insert. ap (mm) 5 0°
G Most effective for unstable machining due to high edge 3
strength and stable insert clamping. 1
Can be used on workpieces requiring close tolerances due to G class 0 0.1 0.3 0.5 0.7
insert tolerance. f (mm/rev)
11° POSITIVE INSERTS WITHOUT HOLE
Finish Cutting Application Breaker Name Features Cross Section
Tolerance and Geometry
Picture
R/L Finishing Carbon Steel • Alloy Steelap (mm) Flank
A parallel chipbreaker. 3 Nose
Flank
G Good chip control for low to medium feed rates. 2 15° Nose
1 Flank
0 0.1 0.2 0.3 0.4
f (mm/rev)
Standard Light to medium cutting of carbon steel, alloy steel Carbon Steel • Alloy Steel
and stainless steel
Light to Medium Cutting 3ap (mm)
Standard, general purpose chipbreaker. 0°
2
1
0 0.1 0.2 0.3 0.4 0°
f (mm/rev)
M Light to medium cutting of carbon steel, alloy steel Carbon Steel • Alloy Steel
80 and stainless steel 3 7°
Large chip pocket for excellent chip evacuation. 2ap (mm)
Double breakers in the rake face achieves a wide range of chip
breaking. 1
0 0.1 0.2 0.3 0.4 7°
f (mm/rev)
Flat Top Heavy cutting of cast iron Cast Ironap (mm) 0°
Most effective for unstable machining due to high edge 3
M strength and stable insert clamping. 2
For Cast Iron 1
0 0.1 0.2 0.3 0.4
f (mm/rev)
Flat Top For cast iron Cast Iron
Most effective for unstable machining due to high edge 3
ap (mm)
G strength and stable insert clamping. 2 0°
Can be used on workpieces requiring close tolerances due to G class 1
insert tolerance. 0 0.1 0.2 0.3 0.4
f (mm/rev)
A068 info@mitsubishitools.ru www.mitsubishitools.ru