2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
iMX-R4F
Roughing head, 4 flute
RECOMMENDED CUTTING CONDITIONS SQUARE
y Side milling
Carbon steel, Alloy steel, Mild Steel, Copper, Pre-hardened steel, Carbon steel, Alloy steel, Austenitic stainless steel,
Work Copper alloys Alloy tool steel Ferritic, Precipitation hardening stainless steel,
material Titanium alloy
Dia. Cutting speed Revolution Feed Feed rate Depth of cut Depth of cut Cutting speed Revolution Feed Feed rate Depth of cut Depth of cut Cutting speed Revolution Feed Feed rate Depth of cut Depth of cut BALL
(mm) (m/min) (min-1) (mm/tooth) (mm/min) ap (mm) ae (mm) (m/min) (min-1) (mm/tooth) (mm/min) ap (mm) ae (mm) (m/min) (min-1) (mm/tooth) (mm/min) ap (mm) ae (mm)
10 150 4800 0.045 860 8 4 120 3800 0.03 460 8 4 100 3200 0.0375 480 8 4
12 150 4000 0.045 720 9.6 4.8 120 3200 0.0325 420 9.6 4.8 100 2700 0.04 430 9.6 4.8
16 150 3000 0.05 600 12.8 6.4 120 2400 0.0375 360 12.8 6.4 100 2000 0.045 360 12.8 6.4
20 150 2400 0.05 480 16 8 120 1900 0.0375 290 16 8 100 1600 0.045 290 16 8
25 150 1900 0.06 460 20 10 120 1500 0.0375 230 20 10 100 1300 0.045 230 20 10 RADIUS
Depth of ae
cut ap
Precipitation hardening stainless steel, Heat resistant alloys
Work Cobalt chromium alloy Inconel718
material
Dia. Cutting speed Revolution Feed Feed rate Depth of cut Depth of cut Cutting speed Revolution Feed Feed rate Depth of cut Depth of cut INDEXABLE HEAD END MILLS
(mm) (m/min) (min-1) (mm/tooth) (mm/min) ap (mm) ae (mm) (m/min) (min-1) (mm/tooth) (mm/min) ap (mm) ae (mm)
10 75 2400 0.03 290 8 4 40 1300 0.04 210 8 1
12 75 2000 0.0325 260 9.6 4.8 40 1100 0.045 200 9.6 1.2
16 75 1500 0.0375 230 12.8 6.4 40 800 0.05 160 12.8 1.6
20 75 1200 0.0375 180 16 8 40 640 0.05 130 16 2
40 510 0.05 100 20 2.5
25 75 950 0.0375 140 20 10
Depth of ae
cut ap
1) For stainless steel, titanium alloy and heat resistant alloy, the use of water-soluble coolant is effective.
2) If the depth of cut is shallow, the revolution and feed rate can be increased.
3) Vibration may occur if the rigidity of machine or workpiece is low.
In this case, please reduce the revolution and feed rate proportionately, or set a lower depth of cut.
info@mitsubishitools.ru www.mitsubishitools.ru I347
