2014-Полный каталог по сверлам EN

                                                                                         Для заказа - info@mitsubishitools.ru               UWC       140°

                     DRILLING (SOLID CARBIDE)                                                                                                                     Thinning

                     MNS

                     RECOMMENDED CUTTING CONDITIONS

                     MNS Type Drill

                         Work Material          Drill LengthType  & 3.0  & 6.0                        Drill Diameter                            & 10.0  & 14.0
                                                                                                        & 6.0  & 10.0
                     N Aluminium Alloy Casting       L/D 3, 5, 8
                                                    L/D 10 30    Cutting Speed (m/min) Feed (mm/rev)  Cutting Speed (m/min) Feed (mm/rev)  Cutting Speed (m/min) Feed (mm/rev)
                         Aluminium Die Casting
                                                                  80  150   0.20 0.50                100 200                0.30 1.00   150 250        0.3 01.00

                                                                  60  120   0.20 0.50                80 150                 0.30 1.00   120 200        0.3 01.00

                     Wrought Aluminium Alloy    L/D 3, 5, 8       80  150   0.15 0.30                100 200                0.20 0.40   150 250        0.2 0 0.40
                                                L/D 10 30        60 120    0.15 0.30                 80  150               0.20 0.40   120 200        0.2 00.40

                         Work Material          Drill LengthType              Drill Diameter
                                                                                 & 14.0  & 20.0
                     N Aluminium Alloy Casting       L/D 3, 5, 8  Cutting Speed (m/min) Feed (mm/rev)
                                                    L/D 10 30
                         Aluminium Die Casting                    150  250  0.30 1.00

                                                                  

                     Wrought Aluminium Alloy    L/D 3, 5, 8       150  250  0.30 1.00
                                                L/D 10 30                        

                     (Note 1) When using a drill with a length over l/d 10, it is necessary to use a pilot hole as a guide.
                                  (If no pilot-hole is used then drill breakage can occur)

                     (Note 2) For pilot hole drilling, Mitsubishi Materials MNS, MAE-MB or MAS-MB drill is recommended.

DRILLING MNS DRILLS

CUTTING
    DATA

D116                                                                         info@mitsubishitools.ru
                                                                             www.mitsubishitools.ru