2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
ROTATING TOOLS
INSERTS
Coated Dimensions (mm)
Shape Order Number EP6120 D1 R L1 F1 S1 Geometry
VP15TF
MP8010
* SRFT10 aaa 10 5 8.5 0.5 2.6 F1
* 12 aaa 12 6 10 0.5 3 L1
* 16 aaa 16 8 12 1 4
* 20 aaa 20 10 15 1 5 R S1
* 25 aaa 25 12.5 18.5 1 6 D1
* 30 aaa 30 15 22.5 1 7
* 32 aaa 32 16 23.5 1 7 R L1
10 5 8.5 2.6 D1
SRBT10 a 12 6 10 3 S1
12 a 16 8 12 4
16 a 20 10 15 5
20 a 25 12.5 18.5 6
25 a 30 15 22.5 7
30 a 32 16 23.5 7
32 a
* 2 inserts supplied per case. =
RECOMMENDED CUTTING CONDITIONS
Work Material Hardness Grade Cutting Speed Feed per Tooth Depth of Cut
vc fz ap
ROTATING TOOLS P Carbon Steel 180 280HB EP6120
Alloy Steel VP15TF (m/min) (mm/tooth) (mm)
< 45HRC EP6120 200 (80 300) 0.2 (0.1 0.3) < 0.05D1
Pre-Hardened Steel VP15TF 150 (80 200) 0.2 (0.1 0.3) < 0.05D1
Alloy Tool Steel 180 380HB EP6120 150 (80 200) 0.2 (0.1 0.3) < 0.05D1
Tensile Strength VP15TF 250 (180 450) 0.2 (0.1 0.3) < 0.05D1
K Gray Cast Iron 200 (80 300) 0.2 (0.1 0.3) < 0.05D1
Ductile Cast Iron < 350MPa MP8010 100 (60 120) 0.2 (0.1 0.3) < 0.05D1
Tensile Strength
H Hardened Steel MP8010
< 800MPa
45 55HRC MP8010
Hardened Steel 55 65HRC MP8010 80 (60 120) 0.2 (0.1 0.3) < 0.01D1
(Note 1) The above values are average condition values at actual cutting speeds. The values change slightly according to the state of a machine
to be used and method of workholding. Adjust the values depending on an actual machine condition, referring to the above values.
(Note 2) For end mills with a carbide shank, you will be able to set about 20 percent higher cutting conditions.
(Note 3) Please note the following when machining hardened steel with MP8010.
• Shorten tool overhang as much as possible.
• Use a carbide shank type.
• Depth of cut setting is important to prevent fracture.
a : Inventory maintained.
K094 info@mitsubishitools.ru www.mitsubishitools.ru