2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                для заказа - info@mitsubishitools.ru

CUTTING SPEED FORMULAE

1.	Employing '° Calculate cutting speed at point P.                                             D1
	 (Cutting speed at the cutting depth border for oblique machining)                                      Q

Formula : Cutting Speed =  ) • D1 • sin ' • n  (m/min)
                                  1000

                           ' °=cos-1(  D1-2ap  )+90  %
                                         D1

                           n : Spindle Speed (min-1)                 %°

2.	Employing ap Calculate cutting speed at point Q.                  apP
	 (Cutting speed at the cutting depth border)                                                                        ap'
                                                                        °
Formula : Cutting Speed =  2)n   ap (D1-ap)    (m/min)
                                1000

                           n	: Spindle Speed (min-1)

                           D1	: Cutting Edge Diameter (mm)
                           ap	: Depth of Cut (mm)

FITTING INSERTS ON HOLDERS                                                                      Concave Mark

   1. Clean the insert seat

       Thoroughly clean the insert and seat in the holder body.

   2. Fitting the insert

       Place the concave mark on the insert uppermost as shown with the clamp screw
       inserted from above (only SRF type inserts). Fasten the clamp screw while firmly
       pressing the insert against the insert seat wall. Use of a special anti seize lubricant
       MK1KS is recommended. Tighten within the recommended torque range.

                                                                                                                         ROTATING TOOLS

                                                                                                SPARE PARTS              M001
                                                                                                TECHNICAL DATA
                                                                                                                         N001 K095
                           info@mitsubishitools.ru       www.mitsubishitools.ru