2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

CARBIDE                                                                       для заказа - info@mitsubishitools.ru

          DRILLING (INDEXABLE TYPE)

          TAW

          yNOTES ON USE

            INSERT INSTALLATION

          a	Remove the clamp screw to install the insert. (H type insert)
          a	Loosen the clamp screw to install the insert. (U type insert)
          a	Correctly mesh the insert and the holder serrations, then slide the insert to the bottom of the slot.
          a	Fasten the clamp screw using the torque wrench provided while holding the insert lightly as shown. (Figure 1)
          a	Check there is no gap between the bottom of the insert and holder. (Figure 2)

                  OK                                                                             NO

          Fig. 1                                                                              Fig. 2                Clearance

            INSERT REPLACEMENT

          a	Thoroughly clean the serrations of the holder before installing a new insert.
          	 Remove heavy dirt in the holder serrations by using the cleaning plate provided.

DRILLING

L134              info@mitsubishitools.ru  www.mitsubishitools.ru