2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
TURNING INSERTS
Symbol Diameter of
Inscribed Circle
(mm)
02 04 03 03 06 3.97 *Thickness is from the bottom of the insert
to the top of the cutting edge.
L3 08 05 04 04 08 4.76
Symbol Thickness (mm)
03 09 06 05 05 09 5.56
06 6.00 S1 1.39
04 11 07 06 06 11 6.35 01 1.59
05 13 09 08 07 13 7.94 T0 1.79
08 8.00 02 2.38
09 06 16 11 09 09 16 9.525 T2 2.78
10 10.00 03 3.18
12 12.00 T3 3.97
12 08 22 15 12 12 22 12.70 04 4.76
15 10 19 16 15 27 15.875 06 6.35
16 16.00
19 13 23 19 19 33 19.05 07 7.94
20 20.00 09 9.52
27 22 22 38 22.225 n Symbol for Insert Thickness
25 25.00
25 31 25 25 44 25.40
31 38 32 31 54 31.75
32 32.00
b Symbol for Insert Size / Symbol for Chip Breaker
LP MP RP
bn /
LM MM RM
12 04 08 (E) (N)- MP
m,.
m Symbol for Insert Corner Configuration , Symbol for Cutting Edge Condition . Symbol for Cutting Direction LK MK RK
Symbol Corner Radius (mm) Figure Cutting Edge Symbol Figure Hand Symbol
00 Sharp Nose Sharp F Right R LS MS RS
V3 0.03 Cutting Edges
V5 0.05
01 0.1 Round E Left L
02 0.2 Cutting Edges Neutral N
04 0.4
08 0.8 Chamfered T FP LP MP
12 1.2 Cutting Edges MA SW MW
16 1.6
20 2.0 Chamfered S
24 2.4 and Rounded
Cutting Edges
28 2.8 Mitsubishi Materials omit HZ HX HV
32 3.2 the honing symbol.
00 : Inch Round Insert
M0 : Metric
(Refer to JIS-B4120-1998)
info@mitsubishitools.ru www.mitsubishitools.ru A003