2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                               для заказа - info@mitsubishitools.ru

          GROOVING SYSTEM

           INSERT                                                                                        Selection of groove widths

          a A WIDE SELECTION OF INSERTS

          Breaker system

                                                          Grooving

          GUBreaker                  GSBreaker    GMBreaker                     GFGS

          (For Gummy Steel)          (Low feeds)  (Medium feeds)                (For Hardened material)

                                                                                                         Different corner radii available

GROOVING                     For Multifunctional Grooving                       Copying/Recessing

          MFBreaker                  MSBreaker    MMBreaker                     BMBreaker

          (Finishing)                (Low feeds)  (Medium feeds)

                                                  Cutting Off                                            MF Breaker

                                                                                                             Efficient chip breaking
                                                                                                             when cross-feed
                                                                                                             machining.

          GUBreaker                  GSBreaker    GMBreaker                     R/L05-GMBreaker          Chips are controlled
                                                                                                         when finish machining.
          (For Gummy Steel)          (Low feeds)  (Medium feeds)                (Medium feeds)

          a INSERT GRADE

                      Work Material      P                         M              K                             S                                   H
          Machining
          Condition                        Steel               Stainless Steel  Cast Iron                Heat resistant Alloy / Titanium Alloy  Hardened steel

                    Stable           NX2525                    VP10RT
                                                               VP20RT
                                     MY5015                                                              VP10RT                                 MB8025

          Machining                  VP10RT                                     MY5015                   RT9010
          Condition
                                                                                VP10RT
                                     VP20RT                                     VP20RT                   VP20RT

                   Unstable

          Note1) VP20RT is the first recommended grade for materials other than hardened steel.
          Note2) For VP10RT, VP20RT and MY5015, wet cutting is recommended.

F006                                              info@mitsubishitools.ru       www.mitsubishitools.ru