2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                для заказа - info@mitsubishitools.ru

                                                                                                                    TURNING INSERTS

Finish Cutting                                                                           Stable Cutting
                                                                                         General Cutting
  FJ                                                                                     Unstable Cutting

 RT9010                                                                           F Finish Cutting

 FJ

RT9010

 FJ

RT9010

S Titanium Alloy (ex. Ti-6Al-4V)                      1st Recommendation                       vc	 : Cutting Speed
             7° POSITIVE INSERTS WITH HOLE                                                     	 f	 : Feed
                                                                                               ap	: Depth of Cut
                  Cutting Area  Chip Breaker  Grade                   vc (m/min)  f (mm/rev)
                                      FJ                                                           ap (mm)
Stable Cutting        F               FJ      RT9010                  30  75     0.04  0.12    0.20  1.40
General Cutting       F               FJ                                                         0.20  1.40
Unstable Cutting      F                       RT9010                  30  75     0.04  0.12    0.20  1.40

                                              RT9010                  30  75     0.04  0.12

                  info@mitsubishitools.ru     www.mitsubishitools.ru              A021CLASSIFICATION A056