2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
TURNING INSERTS
Finish Cutting Light Cutting Medium Cutting Stable Cutting
R-R/L Flat Top Flat Top General Cutting
NX2525 UC5105 UC5105
Unstable Cutting
R-R/L Flat Top Flat Top
NX2525 UC5115 UC5115 F Finish Cutting
L Light Cutting
M Medium Cutting
R-R/L Flat Top Flat Top
UTi20T VP15TF VP15TF
K Cast Iron (ex. GG30) 1st Recommendation vc : Cutting Speed
11° POSITIVE INSERTS WITHOUT HOLE f : Feed
ap : Depth of Cut
Cutting Area Chip Breaker Grade vc (m/min) f (mm/rev)
R-R/L ap (mm)
F Flat Top NX2525 150 205 0.05 0.12 0.20 0.60
L Flat Top 0.30 2.00
R-R/L UC5105 135 250 0.08 0.30 0.30 2.00
Flat Top 0.20 0.60
Stable Cutting M Flat Top UC5105 135 250 0.08 0.30 0.30 2.00
R-R/L 0.30 2.00
F Flat Top NX2525 150 205 0.05 0.12 0.20 0.60
Flat Top 0.30 2.00
L UC5115 130 245 0.08 0.30 0.30 2.00
General Cutting M UC5115 130 245 0.08 0.30
F UTi20T 80 115 0.05 0.12
L VP15TF 115 160 0.08 0.30
M
Unstable Cutting VP15TF 115 160 0.08 0.30
*Please refer to page A091 for other cast iron.
info@mitsubishitools.ru www.mitsubishitools.ru A025CLASSIFICATION A062