2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
TURNING INSERTS
TURNING INSERTS
Depth of Cut (mm)
Depth of Cut (mm)
Depth of Cut (mm)
PRECISION BREAKER SYSTEM
ANGULAR AND PARALLEL CHIP BREAKER 3-D CHIP BREAKER
yCHIP CONTROL RANGE yCHIP CONTROL RANGE
• Carbon Steel • Alloy Steel • Carbon Steel • Alloy Steel • Difficult-to-Cut Materials
• Stainless Steel • Stainless Steel
MJ
SN Standard Standard
Breaker
Breaker SMG MV
FJ
SS R/L Breaker Breaker
Breaker
Breaker Breaker SV
FV Breaker
SR F
Breaker Breaker Breaker
FS
Breaker
Feed (mm/rev) Feed (mm/rev) Feed (mm/rev)
yFEATURES OF CHIP BREAKER
Breaker Features CCGH/CCGT CCMH/CCMT DCMT DCGT TCGT/TCMT TPMH VBGT/VBMT VCMT WBMT/WCGT
Type CPMH/CPMT Type Type Type Type Type Type Type
Type
a For medium cutting.
a 3D moulded chipbreaker
SMG a provides good chip control.
(G class) G class insert gives sharp cutting action,
allowing high precision machining.
a Sharp cutting edge and low
resistance design achieves
(M FV a excellent cutting performance.
class) Suitable for low depths of cut
and low feed rates.
a For light cutting.
SV a A peninsular dot ensures chip
(M class) control at depths of cut under
1mm.
a A positive insert and the large rake angle
achieve sharp cutting edge performance.
MV a The double breakers and round-shaped
(M class) dots in the rake face achieve a wide
range of chip discharge.
a For medium cutting.
a Balance of edge strength and
Standard sharpness due to a and
(M class) combination of a flat land
large rake angle.
a The curved edge allows
smooth chip discharge.
FJ a The large rake angle highly
suitable for finishing
difficult-to-cut materials.
a The curved edge allows
smooth chip discharge.
MJ a Large rake angle highly suitable for
finish-light cutting difficult-to-cut
materials.
Breaker Features CCGH/CCGT CPGT DCGT TPGH TPGV/TPGT TCGT VBGT/VCGT WBGT WCGT WPGT
Type Type Type Type Type Type Type Type Type Type
a For precision finishing.
a Small width lead breaker for
FS excellent chip control.
a Sharp cutting edge gives a
good surface finish.
a For finish cutting.
F a Lead breaker controls chip flow.
a Sharp cutting edge gives a
good surface finish.
a Lead breaker for light cutting.
R/L a Good chip control for low to
medium feed rates.
a For light cutting.
Standard a Good chip control for low to
medium feed rates.
Breaker Features CCET Type CCGT Type DCET Type DCGT Type VBET Type
aThe wide lead breaker for medium
cutting is suitable for automatic
SR lathe machining.
a The insert design for low
resistance controls chip flow.
a The parallel breaker for light
cutting is suitable for automatic
SS lathe machining.
a Excellent chip control at low
feed rates.
a The parallel breaker for general
purpose is suitable for automatic
SN lathe machining.
a Excellent chip control for low to
medium feed rates.
A026 info@mitsubishitools.ru www.mitsubishitools.ru