2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                                                                  для заказа - info@mitsubishitools.ru

      GROOVING SYSTEM

      RECOMMENDED CUTTING CONDITIONS [Face Grooving]

      GROOVING

      Seat size             *a M : Sintered (GY M-)                                               Seat size                           : 1st recommended area

                           J                                                                 0.2              *a G : Ground (GY G-)
                           H
                           G                                                                                 J
                           F                                                                                 H
                           E                                                                                 G
                           D                                                                                 F
                                                                                                             E
                             0 0.05 0.1 0.15                                                                 D
                                               Feed (mm/rev)
                                                                                                               0 0.05 0.1 0.15
                                                                                                                           Feed (mm/rev)

      PLUNGING

GROOVING                    *a M : Sintered (GY M-)                                               Seat size                           : 1st recommended area
                Seat size
                           J                                                                                  *a G : Ground (GY G-)
                           H                                                                 0.2                                                              * After the 1st plunge, the width of cut should be
                           G                                                                                 J                                                  set narrower than insert with W3.
                           F                                                                                 H
                           E                                                                                 G
                           D                                                                                 F
                                                                                                             E
                             0 0.05 0.1 0.15                                                                 D
                                               Feed (mm/rev)
                                                                                                               0 0.05 0.1 0.15
                                                                                                                           Feed (mm/rev)

      TRAVERSE MACHINING (MF BREAKER)

                           Radial Depth of cut (mm)  3.0                                                        Seat Size
                                                                                  Seat size                        (mm)

                                                     2.5 J                                                   D  2.00  G  4.00
                                                                               H                                2.24     4.24

                                                     2.0                                                         2.39 4.75
                                                                           G                                 E 2.50 H 5.00

                                                     1.5 F                                                       2.74 5.24

                                                     1.0 E                                                       3.00 6.00
                                                                                                             F 3.18 J 6.31
                                                     0.5 D
                                                                                                                 3.24 6.35

                                                     0 0.05 0.1 0.15 0.2
                                                                    Feed (mm/rev)

      TRAVERSE MACHINING (MM/MS BREAKER)Axial Depth of Cut (mm)

                   3.0
                                       Seat size
                                       J

                                   H
                   2.0

                                  G
                                F
                   1.0 E

                                                           D  0.1 0.2                        0.3
                                                     0          Feed (mm/rev)

      TRAVERSE MACHINING (BM BREAKER)

                   3.0

                           Axial Depth of Cut (mm)                     Seat size
                                                     2.0 J

                                                                   H
                                                                  G
                                                     1.0 F
                                                             E

                                                            D
                                                         0 0.2 0.4 0.6

                                                                         Feed (mm/rev)

F104                                                                                              info@mitsubishitools.ru      www.mitsubishitools.ru