2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
MS2SS MS2MS CARBIDE
End mill, Short cut length, 2 flute End mill, Medium cut length, 2 flute
RECOMMENDED CUTTING CONDITIONS
Work Carbon steel, Cast iron, Alloy steel, Hardened steel (45 55HRC)
material Pre-hardened steel X40CrMoV51
Cf53, GG25
Dia. Revolution Feed rate Depth of cut Revolution Feed rate Depth of cut
(mm) (min-1) (mm/min) (mm) (min-1) (mm/min) (mm)
0.1 40000 40 0.001 40000 40 0.001
0.2 40000 40000 100 0.002
0.3 40000 100 0.002 40000 200 0.005
0.4 40000 40000 600 0.01
0.5 40000 200 0.005 40000 960 0.015
0.6 40000 40000 1200 0.02
0.7 40000 600 0.01 40000 1400 0.02
0.8 40000 40000 1600 0.03
0.9 40000 1000 0.015 40000 1600 0.04
1 40000 32000 1600 0.06
1.5 40000 1200 0.02 32000 1900 0.08
2 30000 24000 1900 0.10
2.5 24000 1400 0.02 19000 1600 0.13
3 20000 16000 1400 0.15
4 15000 1600 0.03 12000 1200 0.20
5 12000 900 0.25
6 10000 1800 0.04 9000 700 0.30
8 7000 550 0.40
10 8000 2000 0.06 5600 500 0.50
12 6400 4500 450 0.50
16 5400 3000 0.12 3800 100 0.80
20 2400 1200 1.00
1900 3000 0.18 1000 80
2600 0.25
2300 0.30
2000 0.40
1600 0.50
1400 0.60 SOLID END MILLS
1000 0.80
900 1.00
820 1.00
380 3.00
320 4.00
< Please refer to the list above D
for depth of cut.
< Please refer to the list above
Depth of < 1D for depth of cut.
cut
D:Dia.
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) When slotting with end mills with & 3 or larger, reduce the revolution to 50 70% and the feed rate to 40 60%.
3) When drilling, please set the feed rate at 1/3 or below the values above.
4) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and
feed rate proportionately.
info@mitsubishitools.ru www.mitsubishitools.ru I039