2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                             для заказа - info@mitsubishitools.ru

                 MSTAR END MILLS

CARBIDE          MS4EC
                 End mill, 4 flute, For small automatic lathe

                 RECOMMENDED CUTTING CONDITIONS

                           Carbon steel, Cast iron,          Alloy steel, Tool steel,             Austenitic stainless steel,  Hardened steel (45  55HRC)
                           Alloy steel (  30HRC)            Pre-hardened steel                   Titanium alloy
                  Work
                 material  Cf53, GG25                        X40CrMoV51                           X5CrNi1810, X5CrNiMo17122,   X40CrMoV51
                                                                                                  Ti6Al4V
                                                                                                                                   Revolution
                 Dia.      Revolution  Feed rate             Revolution                Feed rate  Revolution  Feed rate               (min-1)  Feed rate
                 (mm)        (min-1)   (mm/min)                (min-1)                 (mm/min)     (min-1)   (mm/min)                         (mm/min)
                                                                                                                                     5000
                   3        10000        900                   7000                      600        6000        450                  4000        180
                   4          7500       900                   5200                      600        4500        450                  3200        180
                   5          6000       900                   4200                      600        3600        450                  2700        180
                   6          5000       900                   3500                      600        3000        450                  2300        180
                   7          4500       840                   3000                      540        2700        420                  2000        160
                   8          4000       780                   2800                      520        2400        390                  1600        160
                 10           3200       680                   2200                      450        1900        340                  1300        140
                 12           2700       620                   1900                      410        1600        310                  1200        120
                 14           2300       550                   1600                      350        1400        280                              120

                                                     < 0.2D  D                           < 0.2D                                < 0.05D         D
                                                     < 1D                                                                      < 1D                            < 0.1D
                 Depth of
                    cut

SOLID END MILLS                                                                                                                                                                                                                    D:Dia.

                 1)	When cutting austenitic stainless steels, the use of water-soluble cutting fluid is effective.
                 2)	If the depth of cut is shallow, the revolution and feed rate can be increased.
                 3)	When drilling, please set the feed rate at 1/3 or below the values above.
                 4)	If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and

                    feed rate proportionately.

I072                                                         info@mitsubishitools.ru              www.mitsubishitools.ru