2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
для заказа - info@mitsubishitools.ru
VFSFPRCH UWC VF 30° CARBIDE
Roughing end mill, Short cut length, 4 flute,
with multiple internal through coolant holes
Carbon Steel, Alloy Steel, Cast Iron Tool Steel, Pre-Hardened Steel, Hardened Steel Hardened Steel Hardened Steel Austenitic Titanium Alloy, Copper Alloy Aluminium Alloy
(<30HRC) ( < 45HRC) ( < 55HRC) Stainless Steel Heat Resistant Alloy
(>55HRC)
e e
CoolStar D1 Type1 SQUARE
END MILLS ap D4(h6)
L1
BALL
h6 D4=16 D4=20 RADIUS
0 0
- 0.011 - 0.013
a Roughing end mill with multiple internal through coolant holes suitable for difficult-to-cut materials.
Unit : mm
Order Number D1 ap L1 D4 Flutes Type Stock TAPER
VFSFPRCHD1600 16 33 90 16 4 a 1
D2000 20 38 100 20 4 a 1
RECOMMENDED CUTTING CONDITIONS y Slotting SOLID END MILLS
y Shoulder milling
Austenitic stainless steel, Heat resistant alloys Austenitic stainless steel,
Work Titanium alloy Inconel718 Work Titanium alloy
material X5CrNi1810, X5CrNiMo17-12-2, material X5CrNi1810, X5CrNiMo17-12-2,
Ti6Al4V Ti6Al4V
Dia. Revolution Feed rate Revolution Feed rate Dia. Revolution Feed rate
(mm) (min-1) (mm/min) (min-1) (mm/min) (mm) (min-1) (mm/min)
16 1200 300 800 110 16 800 100
20 1000 300 600 100 20 600 80
< 0.5D < 0.3D D
0.5D 1.5D 0.5D 1.0D
Depth of Depth of 0.5D 1.0D
cut cut
D:Dia. D:Dia.
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and
feed rate proportionately.
a : Inventory maintained.
info@mitsubishitools.ru www.mitsubishitools.ru I165