2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

CARBIDE                                                                             для заказа - info@mitsubishitools.ru                                     UWC            VF            28.5°
                                                                                                                                                                                            30°
                 IMPACT MIRACLE END MILLS                                                                                                                                   Copper Alloy   Aluminium Alloy

                 VF6SVRCH                                                                                                                                                                              Type1

                 Roughing end mill, Short cut length, 6 flute, Irregular helix flutes,
                 with multiple internal through coolant holes

                 Carbon Steel, Alloy Steel, Cast Iron Tool Steel, Pre-Hardened Steel, Hardened Steel Hardened Steel  Hardened Steel     Austenitic       Titanium Alloy,
                 (<30HRC)              ( < 45HRC)          ( < 55HRC)                                                                Stainless Steel  Heat Resistant Alloy
                                                                                                                       (>55HRC)
                                                                                                                                           e                   e

SQUARE                     CoolStar                                                                                                                   D1
                                                                                                                                                                                                                 D4(h6)
                           END MILLS                                                                                                                         ap
                                                                                                                                                                            L1

BALL

RADIUS           h6         D4=16       D4=20

                           	0          	0
                           -	0.011     -	0.013

                 aRoughing end mill with multiple internal through coolant holes suitable for difficult-to-cut materials.

                                                                                                                                                                                                                          Unit : mm

TAPER                         Order Number                 D1 ap L1 D4 Flutes Type                                                                                                        Stock

                           VF6SVRCHD1600                   16 33                                                                                      90 16 6 a 1
                                           D2000
                                                           20 38 100 20 6 a 1

SOLID END MILLS

                   RECOMMENDED CUTTING CONDITIONS

                 y Shoulder milling

                              Austenitic stainless steel,  Heat resistant alloys
                  Work Titanium alloy                      Inconel718
                 material X5CrNi1810, X5CrNiMo17-12-2,

                              Ti6Al4V

                 Dia.      Revolution  Feed rate           Revolution                                                Feed rate
                 (mm)        (min-1)   (mm/min)              (min-1)                                                 (mm/min)

                 16          2400       1200                  800                                                      160
                 20          2000       1000                  640                                                      140

                 Depth of              < 0.3D                                                                        < 0.2D
                    cut                0.5D  1.5D                                                                   0.5D  1.5D

                                                                                                                      D:Dia.

                 1)	If the depth of cut is shallow, the revolution and feed rate can be increased.
                 2)	The irregular helix flute end mill has a larger effect on controlling vibration when compared to standard end mills. However, if the rigidity of

                    the machine or the workpiece installation is poor, vibration or abonrmal sound can occur. In this case, please reduce the revolution and feed
                    rate proportionately, or set a lower depth of cut.

                 a : Inventory maintained.

I166                                                       info@mitsubishitools.ru                                                   www.mitsubishitools.ru