2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                                для заказа - info@mitsubishitools.ru

                                                                                                                                                      CARBIDE

  RECOMMENDED CUTTING CONDITIONS

y Shoulder milling

          Alloy steel, Tool steel,  Austenitic stainless steel,  Heat resistant alloys
          Pre-hardened steel        Titanium alloy
 Work
material  X40CrMoV51                X5CrNi1810, X5CrNiMo17-12-2, Inconel718
                                    Ti6Al4V

Dia.      Revolution  Feed rate     Revolution  Feed rate        Revolution    Feed rate
(mm)        (min-1)   (mm/min)        (min-1)   (mm/min)           (min-1)     (mm/min)

  6        10600       2900           8000       2000              2100           320
  8          8000      2900           6000       2000              1600           300
10           6400      2700           4800       2000              1300           260
12           5300      2700           4000       2000              1100           230
16           4000      2200           3000       1600                             180
20           3200      1900           2400       1400                800          150
                                                                     640
                                                                             < 0.05D
                                    < 0.1D

Depth of                            < 1.5D                                   < 1.5D
   cut

                                                                                                                                              D:Dia.

1)	When cutting austenitic stainless steels, the use of water-soluble cutting fluid is effective.
2)	If the depth of cut is shallow, the revolution and feed rate can be increased.
3)	The irregular helix flute end mill has a larger effect on controlling vibration when compared to standard end mills. However, if the rigidity of

   the machine or the workpiece installation is poor, vibration or abonrmal sound can occur. In this case, please reduce the revolution and feed
   rate proportionately, or set a lower depth of cut.

                                                                                                                                                      SOLID END MILLS

                                    info@mitsubishitools.ru      www.mitsubishitools.ru                                                               I205