2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
CARBIDE для заказа - info@mitsubishitools.ru
VQ END MILLS
VQXL NEW
End mill, Short cut length, 4 flute, Long neck
y Slotting
Carbon steel, Alloy steel, Mild steel, Alloy tool steel, Heat resistant alloys, Pre-hardened steel, Hardened steel
Austenitic stainless steels, Titanium alloys
Work material Cobalt chromium alloy, Copper, Copper alloy
Ck45, 41CrMo4, 36CrNiMo4, X5CrNi189, X5CrNiMo1810, Inconel 718, NAK, X36CrMo17, X40CrMoV51, 55NiCrMoV6, X46Cr13
X2CrNiN1810, X2CrNiMoN1813
Dia. Neck Length Cutting speed Revolution Feed rate Depth of cut ap Cutting speed Revolution Feed rate Depth of cut ap
(min-1) (mm/min) (min-1) (mm/min) (mm)
(mm) (mm) (m/min) (mm) (m/min)
0.2 0.6 20 30000 270 0.03 15 24000 220 0.03
0.3 0.9 30 30000 360 0.04 0.04
0.3 1.5 30 30000 270 0.04 14 15000 180 0.04
0.4 1.2 40 30000 600 0.06 0.06
0.4 2 40 30000 420 0.06 14 15000 140 0.06
0.5 1.5 45 28000 670 0.07 0.07
0.5 2.5 45 28000 450 0.07 15 12000 240 0.07
0.5 3 45 28000 390 0.07 0.07
0.6 3 45 24000 480 0.09 15 12000 170 0.09
0.7 3.5 45 20000 480 0.1 0.1
0.8 2.4 45 18000 720 0.1 15 9500 230 0.1
0.8 3 45 18000 650 0.1 0.1
0.8 4 45 18000 500 0.1 15 9500 150 0.1
15 45 15000 600 0.1 0.1
15 9500 130
15 7800 160
15 6800 140
15 6000 190
15 6000 170
15 6000 140
15 4800 150
Depth of cut ap
SOLID END MILLS 1) VQ coating has less electrical conductivity; therefore an external contact type (electrically transmitted) tool setter may not work.
When measuring the tool length, please use an internal contact type (non-electrical type) tool setter or a laser type tool setter.
2) Effective cutting of stainless steel, titanium alloys and heat-resistant alloys etc. can be achieved with the use of emulsion coolant.
3) Chattering can still occur if the machine rigidity and clamping method are insufficient.
In these cases the feed and speed should be reduced proportionately.
I228 info@mitsubishitools.ru www.mitsubishitools.ru