2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN
CARBIDE для заказа - info@mitsubishitools.ru
CRN COATED END MILLS
CRN2XL
End mill, 2 flute, Long neck, For copper electrodes
RECOMMENDED CUTTING CONDITIONS
Work material Copper, Copper alloys
SOLID END MILLS Dia. Neck length Revolution Feed rate Depth of cut per pass
(mm) (mm) (min-1) (mm/min) (mm)
0.2 0.5 40000 800 0.004
0.3 1.0 40000 700 0.003
0.4 1.5 40000 600 0.002
0.5 1 40000 800 0.007
0.8 3 40000 600 0.002
2 40000 950 0.007
1 4 40000 800 0.003
6 40000 600 0.001
1.5 2 40000 950 0.01
4 40000 800 0.005
2 6 40000 700 0.002
4 40000 1200 0.02
2.5 6 40000 1200 0.015
3 8 40000 1000 0.01
4 6 40000 2000 0.04
5 8 40000 2000 0.03
6 10 30000 1200 0.02
12 30000 1000 0.015
6 40000 2400 0.10
8 40000 2200 0.09
10 40000 2000 0.08
12 30000 1800 0.05
16 20000 1200 0.03
20 15000 800 0.02
6 40000 2400 0.18
8 40000 2200 0.15
10 40000 2000 0.12
12 30000 1500 0.10
16 30000 1000 0.06
20 15000 600 0.03
8 40000 3000 0.20
12 40000 2800 0.15
16 30000 2100 0.10
20 20000 1000 0.08
20 20000 2000 0.12
20 15000 2000 0.30
25 12000 1500 0.35
30 10000 1200 0.40
1) If the depth of cut is shallow, the revolution and feed rate can be increased.
2) Water-soluble cutting fluid is recommended.
3) Cutting condition may be considerably different due to the overhang (milling depth), depth of cut, and machine tools. Please see the above
table as a standard.
I256 info@mitsubishitools.ru www.mitsubishitools.ru