2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

CARBIDE                                                                             для заказа - info@mitsubishitools.ru                                       UWC         30° 37.5°

                 ALIMASTER END MILLS                                                                                                                                       D1 < 2        D1 > 3

                 AM2MB

                 Ball nose end mill, 2 flute, Medium cut length, Relieved neck

                 Carbon Steel, Alloy Steel, Cast Iron Tool Steel, Pre-Hardened Steel, Hardened Steel Hardened Steel  Hardened Steel  Austenitic       Titanium Alloy,      Copper Alloy  Aluminium Alloy
                 (<30HRC)           ( < 45HRC)  ( < 55HRC)
                                                                                                                       (>55HRC)      Stainless Steel Heat Resistant Alloy       u               e

SQUARE                                                                                                                                                         D5           15°
                                                                                                                                                      D1 D1              L1
                                                                                                                                                                                                                       D4 D4RapType1
                                                                                                                                                           L3              L1                                                   Type2

                                                                                                                                                                   D5

BALL                                                                                                                                                  R  ap
                                                                                                                                                               L3

                 R R <6             R>6
                             ±0.01
                                    ±0.02

RADIUS                       D1 <3  3