2014-Полный каталог по сверлам EN
Для заказа - info@mitsubishitools.ru
DRILLING
JFS
JUST FIT SLEEVE
a A sleeve designed to improve the versatility of the TAF drills,
allowing the cutting diameter to be increased in increments of 0.1mm
DRILLING JFS JUST FIT SLEEVE 5 L5
D75 L1
D8
D4* Increase : Size of the increase in the cutting diameter.
S1
Set Order Individual Order Number Stock D7 Dimensions (mm) *Increase Suitable TAF Type Drill–––
JFS Number (S12) TAFS/M/L1200F20
JFS-1 JFS2520-10 a 33 D4 D8 L1 L5 TAFS/M/L1550F20
2520-20 a 33 25 20 43 TAFS/M/L1600F25
JFS-2 2520-30 a 33 25 20 43 30 0.10 TAFS/M/L2450F25
2520-40 a 33 25 20 43 30 0.20 TAFS/M/L2500F32
JFS-3 2520-50 a 33 25 20 43 30 0.30 TAFS/M/L2950F32
a 40 25 20 43 30 0.40
JFS3225-10 a 40 32 25 50 30 0.50
3225-20 a 40 32 25 50 34 0.10
3225-30 a 40 32 25 50 34 0.20
3225-40 a 40 32 25 50 34 0.30
3225-50 a 48 32 25 50 34 0.40
a 48 40 32 55 34 0.50
JFS4032-10 a 48 40 32 55 40 0.10
4032-20 a 48 40 32 55 40 0.20
4032-30 a 48 40 32 55 40 0.30
4032-40 40 32 55 40 0.40
4032-50 40 0.50
y GUIDELINE FOR SELECTING A JUST FIT SLEEVE
Desired = (Drill & + Increase of JFS ) + 0.1mm
(Eg.) Desired diameter is 20.3mm (oversize is taken as 0.1mm).
20.3=(TAFS/M/L2000F25+JFS3225-20)+0.1
TAF Drill : TAFM2000F25
20mm Drill Using JFS an Increase Oversize Just Fit Sleeve [JFS]
of 0.2mm.
: JFS3225-20
(Note) Oversize can vary due to the cutting conditions used, please use the
above as a guideline.
y ORDERING THE JUST FIT SLEEVE
aPurchasing Method 1 aPurchasing Method 2
Oversize can vary due to the cutting conditions used. It is possible to order individually. When placing an
Therefore it is recommended to purchase as a set. order, please use the individual order number.
When placing an order, please use the Set order
number. (5 sleeves/set)
D176 a : Stock Standard info@mitsubishitools.ru
s : Stock Standard in Japan. www.mitsubishitools.ru
r : Non stock, produced to order only