2014-2015 Полный каталог инструмента Mitsubishi (Митсубиси) EN

                                для заказа - info@mitsubishitools.ru

                ROTATING TOOLS

                INSTRUCTIONS FOR USE OF WIPER INSERTS

                Fig.1                                    Fig.2

                a Wiper inserts for ASX445 are single-cornered.
                a When installing the wiper insert, place the insert so that the cutting edge is located as shown Fig.1.

                   Do not install the wiper insert as Fig.2
                a Recommended depth of cut is ap = 0.2-0.5(mm).

                   (Be aware of cutting load if the depth of cut is over the recommendation.)
                a The major cutting edge of a wiper insert should be set inside as shown. This is to prevent heavy loads on the wiper and ensure the

                   regular insert after the wiper takes the cutting load. To prevent fracture, set the feed under 0.2mm/tooth.
                a Excellent finished surfaces can be achieved with one wiper.
                a Set more than 2 wiper inserts, equally spaced, when the feed per revolution is larger than the width of the wiper edge.

                RECOMMENDED CUTTING CONDITIONS WHEN USING A WIPER INSERT

                Work Material   Grade                                                                         Cutting Speed (m/min)

ROTATING TOOLS                                                                                         VP25N  200 (80250)
                                       P                                                                      180 (80 250)

                                                                                                      VP15TF     120 270
                                      M VP15TF
                                                                                                                 130  250
                                                                                                      MC5020
                                       K                                                                          20  50
                                                                                                                  40  80
                                                                                                      VP15TF
                                       S VP15TF
                                       H VP15TF
                a Recommended depth of cut (ap) is 0.2mm-0.5mm, and feed per tooth (fz) is up to 0.2mm/t.

K014                            info@mitsubishitools.ru  www.mitsubishitools.ru